Home제품정보 MotherboardsDP Xeon®Socket 2011Intel C602 Chipset

X9DAX-7F-HFT

견적상담제품문의

Key Features
  • Support Hyper-Speed
  1. Dual socket R (LGA 2011) supports Intel Xeon processor E5-2600
  2. Intel C602 chipset; QPI up to 8.0GT/s
  3. Up to 512GB DDR3 1600MHz ECC Registered DIMM; 16x DIMM sockets
  4. 2 PCI-E 3.0 x16, 3 PCI-E 3.0 x8, 1 UIO PCI-E 3.0 x8 (for SMC UIO HBA) or 1 PCI-E 2.0 x4 (in x8)
  5. Intel i350 Dual port GbE LAN
  6. 8x SATA2 and 2x SATA3 ports
  7. 8x SAS2 ports from LSI 2208
  8. Integrated IPMI 2.0 and KVM with Dedicated LAN
  9. Dual port front and rear USB 3.0
  10. Performance boost with Hyper-Speed

RoHS

Product SKUs
MBD-X9DAX-7F-HFT -O
  • X9DAX-7F-HFT (Standard Retail Pack)
MBD-X9DAX-7F-HFT -B
  • X9DAX-7F-HFT (Bulk Pack)
 
Physical Stats
Form Factor
  • Enhanced Extended ATX
Dimensions
  • 13.68" x 13" (34.74cm x 33cm)
 
Processor/Cache
CPU
  • Intel® Xeon® processor E5-2600 (up to 150W TDP **)
  • Dual Socket R (LGA 2011)
Cache
  • Up to 20MB
System Bus
  • QPI up to 8 GT/s
** Motherboard supports this maximum TDP. Please verify your system can thermally support
 
System Memory
Memory Capacity
  • 16x 240-pin DDR3 DIMM sockets
  • Supports up to 512 GB DDR3 ECC Registered memory (RDIMM)
  • Supports up to 128 GB DDR3 ECC/non-ECC Un-Buffered memory (UDIMM)
Memory Type
  • 1600/1333/1066/800MHz ECC DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs
  • Support ECC and non-ECC UDIMMs
DIMM Sizes
  • 32GB, 16GB, 8GB, 4GB, 2GB, 1GB
Memory Voltage
  • 1.5 V, 1.35 V
Error Detection
  • Corrects single-bit errors
  • Detects double-bit errors (using ECC memory)
 
On-Board Devices
Chipset
  • Intel® C602 chipset
SATA
  • SATA 2.0 3Gbps with RAID 0, 1, 5, 10
  • SATA 3.0 6Gbps with RAID 0, 1
SAS
  • SAS2 from LSI 2208 (1GB cache)
  • HW RAID 0, 1, 5, 6, 10, 50, 60 support
  • Supports up to 16 drives
(Both CPUs need to be installed for SAS controller to be enabled)
IPMI
  • Support for Intelligent Platform Management Interface v.2.0
  • IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
  • Nuvoton WPCM450 BMC
Network Controllers
  • Intel® i350 Dual Port Gigabit Ethernet
  • Virtual Machine Device Queues reduce I/O overhead
  • Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
  • 1x Realtek RTL8201N PHY (dedicated IPMI)
Video
  • Matrox G200eW
Audio
  • RealTek ALC889 7.1 High Definition Audio with S/PDIF header
 
Input / Output
SATA
  • 2 SATA 3.0 ports (6Gbps)
  • 8 SATA 2.0 ports (3Gbps)
SAS
  • 8 SAS2 ports (6Gbps)
LAN
  • 2 RJ45 Gigabit Ethernet LAN ports
  • 1 RJ45 Dedicated IPMI LAN port
USB
  • 4 USB 3.0 ports (2 rear + 2 via header)
  • 7 USB 2.0 ports total
    (4 rear + 2 via header + 1 Type A)
Audio
  • Line-in / Line-out / Microphone Ports
Serial Port / Header
  • 1 Fast UART 16550 Header
IEEE 1394a
  • 2 Headers
DOM
  • 1 DOM (Disk on Module) power connector
TPM
  • 1 TPM 1.2 20-pin Header
 
Chassis ( Optimized for X9DAX-7F-HFT )
2U Chassis
  • CSE-829BTQ-R1K28LPB
Important Chassis Notes
  • To support the new generation Intel® Xeon® processor-based motherboards, Revision M chassis is recommended. Please talk to your sales representative for details.
 
Expansion Slots
PCI-Express
  • 2x PCI-E 3.0 x16
  • 3x PCI-E 3.0 x8
  • 1x UIO PCI-E 3.0 x8 (for SMC UIO HBA) or 1x PCI-E 2.0 x4 (in x8)

    (Both CPUs need to be installed for full access to PCI-E slots and onboard controllers. See manual block diagram for details.)
 
System BIOS
BIOS Type
  • 128Mb SPI Flash EEPROM with AMI BIOS
BIOS Features
  • Plug and Play (PnP)
  • APM 1.2
  • PCI 2.3
  • ACPI 1.0 / 2.0 / 3.0 / 4.0
  • USB Keyboard support
  • SMBIOS 2.7.1
  • UEFI
 
Management
Software
  • SuperDoctor® III
  • Watch Dog
  • NMI
  • IPMI 1.5 / 2.0
Power Configurations
  • ACPI / APM Power Management
  • Power-on mode for AC power recovery
 
PC Health Monitoring
Voltage
  • Monitors for CPU Cores, +1.1V, +1.5V, +3.3V, +5V, +12V, +3.3V Standby, +5V Standby, VBAT, Memory Voltages.
  • 6+1 Phase-switching voltage regulator
FAN
  • 8x 4-pin fan headers (up to 8 fans)
  • 8x fans with tachometer monitoring
  • Status monitor for speed control
  • Pulse Width Modulated (PWM) fan connectors
Temperature
  • Monitoring for CPU and chassis environment
  • CPU thermal trip support
  • Thermal Control for 8x Fan Connectors
  • Thermal Monitor 2 (TM2) support
  • PECI
LED
  • CPU / System Overheat LED
  • Suspend static indicator LED
Other Features
  • Chassis intrusion detection
  • Chassis intrusion header
  • RoHS, Halogen Free
 
Operating Environment
Operating Temperature Range
  • 10°C - 35°C (50°F - 95°F)
Non-Operating Temperature Range
  • -40°C - 70°C (-40°F - 158°F)
Operating Relative Humidity Range
  • 8% - 90% (non-condensing)
Non-Operating Relative Humidity Range
  • 5% - 95% (non-condensing)

Note : X9DAX-7F-HFT is for server SKUs (SYS-6027AX-72RF-HFT1 and SYS-6027AX-72RF-HFT2) only, please contact Supermicro sales for more details.