|
| SYS-7046T-6F |
- SuperServer 7046T-6F (Black)
|
| |
| CPU |
- Dual 1366-pin LGA Sockets
- Supports up to two Intel® 64-bit Xeon® processor(s) of the same type below:
- Intel®
Xeon®Processor 5600 Series (Westmere)
- Intel®
Xeon®Processor 5500 Series (Nehalem-EP)
|
| QPI |
|
| |
| Memory Capacity |
- 12x 240-pin DIMM sockets
- Supports up to 192 GB 1333 / 1066 / 800MHz DDR3 ECC Registered memory
- Supports up to 48 GB 1333 / 1066 / 800MHz DDR3 ECC / Non ECC Unbuffered memory
- Memory Mirroring supported
|
| Memory Type |
- 1333 / 1066 / 800MHz ECC Registered / ECC or Non ECC Unbuffered DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs
|
| DIMM Sizes |
- 1GB, 2GB, 4GB
, 8GB
, 16GB
|
| Memory Voltage |
|
| Error Detection |
- Corrects single-bit errors
- Detects double-bit errors (using ECC memory)
- Supports Intel® x4 and x8 Single Device Data Correction (SDDC)
|
| |
| Chipset |
- Intel® 5520 (Tylersburg) chipset
- ICH10R
|
| SAS |
- LSI 6Gbps SAS 2008
- RAID 0, 1, 10 support
- (Optional: AOC-SAS2-RAID5-KEY) RAID 5 support
|
| SATA |
- Intel ICH10R SATA 3.0Gbps Controller
- RAID 0, 1, 5, 10 support (Windows)
- RAID 0, 1, 10 support (Linux)
|
| Network Controllers |
- 2x Intel® 82574L Gigabit Ethernet Controllers
- Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
- 1x Realtek RTL8201N PHY (dedicated IPMI)
|
| Graphics |
|
| Super I/O |
|
| |
| PCI-Express |
- 3 (x8) PCI-E 2.0 slots
- 1 (x4) PCI-E 2.0 slot
- 1 (x4) PCI-E slot
|
| |
| SAS |
- 8x 6Gbps SAS / SATA ports
|
| Serial ATA |
- Six Serial ATA ports
- Six SATA hard drives supported
|
| LAN |
- 2x RJ45 LAN ports
- 1x RJ45 IPMI port
|
| USB |
- 4x USB rear ports
- 2x USB on-board (TypeA)
- 4x USB internal headers
- Total 8 USB 2.0 Compliant
|
| Keyboard / Mouse |
- PS/2 keyboard and mouse ports
|
| Serial Port / Header |
- 1 Fast UART 16550 serial port
- 1 Fast UART 16550 serial header (Option)
|
| |
| BIOS Type |
- 32Mb SPI Flash EEPROM with AMI® BIOS
|
| BIOS Features |
- Plug and Play (PnP)
- PCI 2.2
- ACPI up to 3.0
- USB Keyboard support
|
|
|
|
| Form Factor |
- 4U Rackmountable / Tower
- Optional Rackmount Kit (CSE-PT26)
|
| Model |
|
| |
|
| Height |
|
| Width |
|
| Depth |
|
| Gross Weight |
|
| Available Colors |
|
| |
|
| Buttons |
- Power On/Off button
- System Reset button
|
| LEDs |
- Power LED
- Hard drive activity LED
- 2x Network activity LEDs
- System Overheat / Fan Fail LED
|
| Ports |
|
| |
|
| Hot-swap |
|
| Peripheral Bay(s) [90o Rotatable] |
- 2x 5.25" Peripheral Drive Bay
- 1x 5.25" Bay for Floppy Drive
|
| |
| SC743 SAS / SATA Backplane w/ Enclosure Management |
| |
|
| Fans |
- 2x 8cm Hot-swappable PWM Cooling Fans
- 1x 9cm Rear Exhaust PWM Fan
- 2x Active heatsink w/ heatpipe
|
| |
|
| 920W high-efficiency (94+%) power supply with PMBus |
| AC Input |
- 100-240 V, 50-60 Hz, 11-4.5 Amp
|
| DC Output |
- 4 Amp @ +5V standby
- 75 Amp @ +12V
|
| With Power Distributor |
- +5V: 30 Amp
- +3.3V: 24 Amp
- -12V: 0.6 Amp
|
| Certification |
  Platinum Certified
[ Test Report ]
|
| |
| CPU |
- Monitors for CPU Cores, +1.8V, +3.3V, +5V, +12V, +3.3V Standby, +5V Standby, VBAT, Memory, Chipset Voltages.
- 6-Phase-switching voltage regulator with auto-sense from 0.8375V-1.60V
|
| FAN |
- Total of eight fan headers supporting up to 8 fans
- Eight 4-pin fan headers
- 8x fans with tachometer status monitoring
- Support 3-pin fans (w/o speed control)
- Low noise fan speed control
|
| Temperature |
- Monitoring for CPU and chassis environment
- Thermal Control for 8x fan connectors
- PECI
|
| Other Features |
- Chassis intrusion detection
- Chassis intrusion header
|
| |
|
| Environmental Spec. |
- Operating Temperature: 10° to 35°C (50° to 95°F)
- Non-operating Temperature: -40° to 70°C (-40° to 158°F)
- Operating Relative Humidity: 8% to 90% (non-condensing)
- Non-operating Relative Humidity: 5 to 95% (non-condensing)
|
|
