|
| SYS-6016T-MTHF |
- SuperServer 6016T-MTHF (Black)
|
| |
| CPU |
- Dual 1366-pin LGA Sockets
- Supports up to two Intel® 64-bit Xeon® processor(s) of the same type below:
- Intel®
Xeon® Processor X5600/E5600/L5600 Series
(Westmere) 40W - 95W
- Intel®
Xeon® Processor X5500/E5500/L5500 Series
(Nehalem-EP) 38W - 95W
|
| QPI |
|
| |
| Memory Capacity |
- 6x 240-pin DIMM sockets
- Supports up to 96 GB** 1333 / 1066 / 800MHz DDR3 ECC Registered memory
- Supports up to 24 GB 1333 / 1066 / 800MHz DDR3 ECC / Non ECC Unbuffered memory
- Memory Mirroring supported
|
| Memory Type |
- 1333 / 1066 / 800MHz ECC Registered / ECC or Non ECC Unbuffered DDR3 SDRAM 72-bit, 240-pin gold-plated DIMMs
|
| DIMM Sizes |
- 1GB, 2GB, 4GB
, 8GB**
, 16GB**
|
| Memory Voltage |
|
| Error Detection |
- Corrects single-bit errors
- Detects double-bit errors (using ECC memory)
- Supports Intel® x4 and x8 Single Device Data Correction (SDDC)
|
| |
| Chipset |
- Intel® 5500 (Tylersburg) chipset
- ICH10R + IOH-24D
|
| SATA |
- Intel ICH10R SATA 3.0Gbps Controller
- RAID 0, 1, 5, 10 support (Windows)
- RAID 0, 1, 10 support (Linux)
|
| IPMI |
- Support for Intelligent Platform Management Interface v.2.0
- IPMI 2.0 with virtual media over LAN and KVM-over-LAN support
- Nuvoton WPCM450 BMC
|
| Network Controllers |
- 2x Intel® 82574L Gigabit Ethernet Controllers
- Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
- 1x Realtek RTL8201N PHY (dedicated IPMI)
|
| Graphics |
|
| Super I/O |
|
| |
| Serial ATA |
- Six Serial ATA ports
- Six SATA hard drives supported
|
| LAN |
- 2x RJ45 LAN ports
- 1x RJ45 Dedicated IPMI LAN port
|
| USB |
- 2x USB rear ports
- 1x USB on-board
- 2x USB internal headers
- Total 6 USB 2.0 Compliant
|
| VGA |
|
| Keyboard / Mouse |
- PS/2 keyboard and mouse ports
|
| Serial Port / Header |
- 1 Fast UART 16550 serial port
- 1 Fast UART 16550 serial header (Option)
|
| |
| BIOS Type |
- 32Mb SPI Flash EEPROM with AMI® BIOS
|
| BIOS Features |
- Plug and Play (PnP)
- PCI 2.2
- ACPI up to 3.0
- USB Keyboard support
|
|
|
| |
|
| Height |
|
| Width |
|
| Depth |
|
| Gross Weight |
|
| Available Colors |
|
| |
|
| Buttons |
- Power On/Off button
- System Reset button
|
| LEDs |
- Power LED
- Hard drive activity LED
- 2x Network activity LEDs
- System Overheat LED
|
| Ports |
- 2x Front USB Ports
- 1x Serial COM Port
|
| Optional Front Bezel |
- Please refer to the
Front Bezel Compatibility Table
|
| |
|
| Hot-swap |
- 4x 3.5" Hot-swap SATA drive bays
|
| |
|
| DVD-ROM |
- Slim DVD-ROM drive (Optional)
|
|
| Fans |
- 4x 4cm heavy duty RPM fans
|
| |
|
| 600W AC multi output power supply w/ PFC |
| AC Voltage |
- 100-240 V, 50-60 Hz, 7.5-3.1 Amp
|
| +5V |
|
| +5V standby |
|
| +12V |
|
| +3.3V |
|
| Certification |
Gold Certified
[ Test Report ]
|
| |
| CPU |
- Monitors for CPU Cores, +1.8V, +3.3V, +5V, +12V, +3.3V Standby, +5V Standby, VBAT, HT, Memory, Chipset Voltages.
- 4-Phase-switching voltage regulator
|
| FAN |
- Total of six fan headers supporting up to 6 fans
- Six 4-pin fan headers
- 6x fans with tachometer status monitoring
- Support 3-pin fans (w/o speed control)
- Low noise fan speed control
|
| Temperature |
- Monitoring for CPU and chassis environment
- Thermal Control for 6x fan connectors
- PECI
|
| Other Features |
- Chassis intrusion detection
- Chassis intrusion header
|
| |
|
RoHS
|
|
| Environmental Spec. |
- Operating Temperature: 10°to 35°C (50°to 95°F)
- Non-operating Temperature: -40°to 70°C (-40°to 158°F)
- Operating Relative Humidity: 8% to 90% (non-condensing)
- Non-operating Relative Humidity: 5 to 95% (non-condensing)
|
|
